How to Change Battery in Dodge Journey FOB

If you own a Dodge Journey, you may find yourself needing to change the battery in your key fob at some point. The key fob is a crucial component of your vehicle, allowing you to unlock and start your car with ease. However, over time, the battery inside the fob may weaken, leading to a dead battery. In this article, we will guide you through the process of changing the battery in your Dodge Journey fob, ensuring that you can continue using it without any issues.

Materials Needed

Before you begin, make sure you have the following materials on hand:

– Replacement battery (CR2032)
– Small flathead screwdriver
– Needle-nose pliers (optional)

Step 1: Power Off Your Vehicle

First and foremost, ensure that your Dodge Journey is turned off and the engine is not running. This will prevent any accidental damage to the vehicle or injury to yourself.

Step 2: Locate the Battery Compartment

Open the driver’s door and locate the key fob compartment on the inside of the door. It is typically found near the door handle or in the door pocket. The compartment may be covered by a plastic cover or a small door.

Step 3: Remove the Battery Compartment Cover

Use the small flathead screwdriver to remove the screws holding the battery compartment cover in place. Set the screws aside and gently lift the cover off to expose the battery.

Step 4: Remove the Old Battery

Locate the old battery inside the compartment. It is usually held in place by a small clip or a sticker. Use the needle-nose pliers to gently remove the old battery from its compartment.

Step 5: Insert the New Battery

Take the new CR2032 battery and insert it into the compartment. Ensure that the battery is oriented correctly, with the positive (+) side facing up. If you’re unsure, refer to the battery’s label for guidance.

Step 6: Reassemble the Battery Compartment

Place the battery compartment cover back on the compartment and secure it with the screws you removed earlier. Tighten the screws firmly but do not overtighten them.

Step 7: Test the Key Fob

Close the driver’s door and test the key fob to ensure that the new battery is working correctly. Press the buttons on the key fob to unlock and lock your Dodge Journey, and try starting the car to confirm that the fob is functioning properly.

Conclusion

Changing the battery in your Dodge Journey fob is a straightforward process that can be completed in just a few minutes. By following these simple steps, you can ensure that your key fob remains functional and that you can continue using it to unlock and start your vehicle. If you encounter any difficulties or have questions, don’t hesitate to consult your vehicle’s owner’s manual or seek assistance from a professional.